ftdi_sio: v1.5.0:USB FTDI Serial Converters Driverīus 005 Device 002: ID 0403:6001 Future Technology Devices International, Ltd FT232 USB-Serial (UART) ICīus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hubīus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub usbcore: registered new interface driver ftdi_sio usb 5-2: FTDI USB Serial Device converter now attached to ttyUSB0 ftdi_sio 5-2:1.0: FTDI USB Serial Device converter detected USB Serial support registered for FTDI USB Serial Device usbcore: registered new interface driver usbserial_generic USB Serial support registered for generic usbcore: registered new interface driver usbserial usb 5-2: configuration #1 chosen from 1 choice usb 5-2: new full speed USB device using uhci_hcd and address 2 ***When I plug the USB from the plotter in to the computer I'm hoping to avoid having to get my hands on a windows machine to see how things work there. When I plug the plotter in to a USB port the device seems to be detected and registered correctly but I haven't gotten any response from the plotter by either piping directly or setting up a RAW cups printer. Will design using inkscape and print using the Tux Plot program ( ) or Bob Story's hpgl-distiller ( ).īut first I need to get the plotter to respond to something, anything, that I send it. I just got a PCut Cutting Plotter for use in cutting vinyl and sand blast resist stencils. This is my first message! I hope you can help.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |